Tried climb milling a 6061 pocket on my little G0704 and the finish came out worse, what am I missing
Honestly I thought I was being smart. I read that climb milling gives a better finish so I switched my roughing pass on a 2 inch deep pocket in 6061, running my little Grizzly G0704 at about 3000 rpm with a 3 flute carbide end mill and a 0.030 stepover, and the walls came out looking chewed up with chatter marks all over them. Backlash is the problem I think, because this machine still has the stock lead screws and I never did the ball screw swap. What happened is the cutter grabbed and pulled into the cut on the climb side and the finish got worse the deeper I went, especially past about an inch of depth. I went back to conventional and it cleaned up, but it still took me two scrapped parts and about 5 hours of messing around before I figured out the backlash was fighting me. So now I'm wondering if I should just live with conventional until I can afford the ball screw kit, or if there's a way to take up the slack that actually works. Has anyone dealt with this on a benchtop mill and got a climb pass to cut clean?